Blue Life Phos Fx

PHOS Fx is an exceptional macroporous phosphate removal resin. Its high capacity, long lasting beads and easy regeneration make it the most cost effective phosphate removal media on the market. PHOS Fx has an unparalleled capacity to adsorb phosphates quickly and safely.

 Most cost effective phosphate media on the market!

Directions: Phos Fx should be rinsed under purified water for a few seconds before use. It can be used in a canister filter, media reactor, filter box or any high flow area of your sump. Use included media bag and zip tie if not being used in reactor.  For 250 gallons of water, use 500ml of product. For first application, use half the suggested amount of product as to not lower phosphates to rapidly. After 48 hours full dose may be administered. Do not lower phosphates more than .5ppm in a 24 hour period. Once product has exhausted you can regenerate up to six times. Regeneration is quick and easy with Blue Life USA’s Phos Fx Regenerate or the formula below.

Regeneration:

Regeneration must be performed in a container outside of the aquarium

High brine solutions like the one in the formula below can be very harsh on the skin and eyes due to the high pH so it is strongly recommended that protective eyewear and rubber gloves be worn as a precautionary measure.

For each 250ml of Phos Fx Resin mix 1 cup of Phos Fx Regenerate with 4 cups of warm to hot tap water in a bucket or pail. Stir until all is disolved. Place media in filter bag that came with media (sel with rubberband or twist tie) and drop into regenerate solution. Let sit for 40-60 minutes, agitating about every ten minutes. Once regenerated, rinse resin thoroughly with filtered fresh water and place back into aquarium. Every time resin is regenerated, the adsorption capacity will decrease. After resin has been regenerated six times, it is exhausted and should be replaced.